Pre-Cut Dark Grey Neoprene Irrigation Dam with Loop

Watering crops in an arid environment can be troublesome. Flood irrigation is one solution which is both effective and cost-efficient. Irrigation dams allow you to direct the water in your irrigation ditch or canal where you want it to go. Each roll of irrigation dam material is cut from one piece of material, so there are no heat seals on the product that can fail. 

 

A loop (or sleeve) is sewn along one edge of the entire length of the roll, which can be cut to whatever widths are needed. The loop allows the use of a 2x4 or a pipe to secure the top of the dam at the surface. The rest of the dam will drape down into the ditch/canal and block the water.

 

Neoprene irrigation dam material is a woven nylon mesh coated in synthetic rubber. It will not rot or mildew, and it's difficult to accidentally shovel cut. Neoprene's most popular feature for irrigation is that it retains its flexibility in the coldest irrigation water. This product is made in the U.S.A.

 

The sizing is based on initial cut size; check the Approx. Finish Sizes list for the approximate finish size of the dam's depth measurement.

Pre-Cut Dark Grey Neoprene Irrigation Dam with Loop

PriceFrom $50.58
    • 6" loop/sleeve sewn with double-needle lock stitch
    • 5-6 stitches per inch
    • Made from one piece of material: no heat seal or seam
    • Material is 4.1 ounces per sq. yard before coating
    • Material is 14 ounces per sq. yard after coating
    • Low temp. tolerance: -55° F (-48° C)
  • Cut
    Size
    Approximate
    Finish Size
    5' x 7' 4'4" Depth x 7’
    5' x 8' 4'4" Depth x 8’
    5' x 9' 4'4" Depth x 9’
    5' x 10' 4'4" Depth x 10’
    6' x 8' 5'4" Depth x 8’
    6' x 9' 5'4" Depth x 9’
    7' x 12' 6'4" Depth x 12’
    9' x 12' 8’4” Depth x 12’